Dynaudio Xeo 6 Owner's Manual download pdf (Page 14)

14 Dynaudio

Connection and operation

This section describes the connections and control elements for the Xeo components. Please contact

your Dynaudio Xeo distributor if you have any problems with connection and start-up. Distributor

addresses can be found in the Internet at www.dynaudio.com.

Remote control

The Xeo remote control can be used to turn the loudspeakers on and off, change the volume, and

select a Hub and its connected signal sources. If the loudspeakers are being operated in stereo mode

(right/left), commands will always apply to both of the loudspeakers.

Control elements

MUTE Mute the loudspeaker

Briey pressing this button will mute or

unmute the selected loudspeaker.

Fixing the volume

Pressing this button for longer than 2 seconds will set a

high volume for the loudspeaker (see page 21).

ON/OFF Loudspeaker on/off

= on

= switch to standby

Reset

= Pressing this button for longer than 5 seconds will

reset the loudspeaker to the factory settings.

VOLUME Changing the volume

= louder, = quieter

INPUT

1/2/3/4

Selecting the signal source

Selects one of the signal sources Line In, Optical In, Coax In or USB In from the active Hub.

HUB

A/B/C

Selecting the Hub

Selects one of the three possible Hubs A, B, or C.

Xeo Hub

The Xeo Hub is the control center for the Xeo system. Signal sources such as tuners, receivers, CD

players, TVs, network players, MP3 players, or computers are connected to it. Signals are sent via

radio from the Xeo Hub to the loudspeakers where they are then played back.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Dynaudio Xeo 6 Owner's Manual Page 14