Dynaudio Xeo 6 Owner's Manual download pdf (Page 21)

Switching on/standby mode

To switch the loudspeaker on from standby mode:

► Point the remote control at the loudspeaker and press the ON button or press on the interface

display.

▼ The loudspeaker will automatically search for an active Hub and an audio signal. If found, the

signal will be output (autoplay function).

If there is no input signal, the loudspeaker will go into standby mode after a certain period.

► To switch it on again, press the ON button or .

To switch a loudspeaker to standby mode:

► Point the remote control at the loudspeaker and press the OFF button or press .

▼ The loudspeaker will go into standby mode. To completely switch off the loudspeaker, turn the

POWER switch on the rear to OFF. However, the loudspeaker can then no longer be switched

on via the remote control.

Selecting a Hub or input/autoplay function

After it is turned on, the loudspeaker automatically searches for an audio signal and then plays it back

immediately. If several signal sources are active, one of the signal sources will be played back. Select

a different Hub or input if you want to play back a different signal source.

To select a different Hub or input:

► Press HUB A, B, or C or INPUT 1, 2, 3, or 4 on the remote control.

▼ The selected signal source will be played back.

Fixing the volume

You can set the loudspeaker to a higher volume using the function to x the volume. This setting

also remains in effect in standby mode. If a signal source is connected to a Hub with its own volume

control, you have the option to change the output volume across a broad range with the signal source.

To x the volume:

► Point the remote control at the loudspeaker and press the MUTE button for longer than 2 seconds.

To undo xing, press one of the two volume buttons.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Dynaudio Xeo 6 Owner's Manual Page 21